DIY cattle prod.... (4)

One problem I have though....the 2 pin plug connector does not fit tightly into the top of the fly swat handle.

Does anyone have any good ideas as to how I can secure it?

I was going to try super-glue tomorrow - but I wonder if there could be a better method?

I always behave. I just don't specify how.
WARNING: Some BDSM activities may run the risk of injury or even death. However life runs the risk of injury and the certainty of death.
The film is called 'Secretary' not 'The Secretary', there is no 'The' in the title, it's just 'SECRETARY'. ARRGGGHHHH!!!!!

I got as far as the Blue Peter advent crown and Tracey Island - but cattle? Damn that sounds complicated!

Why would you want to prod them?

The trouble with this one is that the electronics are very near the top - so not much room to insert the plug.

I'll try some epoxy tomorrow!

Was also thinking that maybe some wide heat-shrink might help?

The ones I've done the electronics are near the bottom, but there is a screw hole part near the top and the plugs have been a little wide to slot in nicely. So I cut away the bit the screw goes through and cut/file away part of the plug so it slots into the handle better. If there isn't much room to hold the plug in then I might look at putting a couple of strips of something on either side of the handle to help hold the plug in place.

I always behave. I just don't specify how.
WARNING: Some BDSM activities may run the risk of injury or even death. However life runs the risk of injury and the certainty of death.
The film is called 'Secretary' not 'The Secretary', there is no 'The' in the title, it's just 'SECRETARY'. ARRGGGHHHH!!!!!